Astoria Networks Easybox LTE. This device is being distributed by Vodafone to their customers. It’s an product of the Arcadyan Subcompany Astoria. See Vodafone EasyBox xDSL/Sysinfo for a lot of (software and hardware) details about the device, including /proc/cpuinfo, /proc/mtd. Overview. Hardware. PCB photos. Vendor Firmware. Download (official Vodafone firmware update binary). Overview · Firmware download.
|Published (Last):||12 November 2012|
|PDF File Size:||6.88 Mb|
|ePub File Size:||4.15 Mb|
|Price:||Free* [*Free Regsitration Required]|
But I am quite stuck right now: Can anyone help me? Also Wifi should work fine in normal AP mode. I think it is a right mananment error on the FS or somthing else. Where I am currently struggling with is asterisk: Thank you very much!
Using static regulatory domain info [ 0. This is the original manufacturer’s firmware, no? I hope you like it.
Since we lost some information on the openwrt forum page, this should be the new home for our device. Thank you for your easyvox. I found a forum entry, that the box is not able to roam. Easybox Hi there. Registered protocol family 20 [ 0.
OpenWrt Project: Astoria Networks Easybox LTE
Can anyone give a conclusion what’s working and not? OK Uncompressing Kernel Image Even with the change from dsl0 to dsl0. PME disabled [ 0. Could someone send the patches for xdsl support to upstream openwrt? Yep, what eaaybox say is also what i am using.
Arcadyan Easybox xDSL – WikiDevi
CC Attribution-Share Alike 4. But unfortunately the dial in doesn’t work. Registered protocol family 8 [ 0.
Mounted root squashfs filesystem readonly on device Open-WRT is working on that box. However, I can’t see what any of this has easynox do with OpenWrt.
It is at a different position on the LTE board.
I think thanks to the by hailfinger mentioned drivers this should be finally possible. Carefully reading posts helped me.
Vodafone Easybox 904 xDSL
It is enough to change ifname ‘dsl0’ to ifname ‘dsl0. Unfortunately the WLAN doesn’t work either. My second usb-slot does not work but i fear it is an elektrical problem or have everyone the same problem?
That was dasybox to a completely different reason: But i get a permanent boot loop. So i will inform you, if that worked in Italy with no roaming. I get no dial in or VoIP working on my Easyboxxdsl. Even if it takes some time. But maybe there is already some further development.
Okay, the first part i figured out: The serial console logged lentiq,xrxnet 1e Then just added this interface to the firewall-zone “wan”, and the device and clients had internet!
Photo of PCB with markings. Except where otherwise noted, content on this wiki is licensed under the following license: So I simply created a new interface via webinterface with protocol “DHCP client” and under “Physical settings” the “Interface” to “eth0.
I’m happy that you got your box back into working state I would disagree that it was “bricked” in the first placeand I can share your joy about that. Uncompressing LCD bootup images Now you can access the box via telnet: Ralink iNIC at 0x0, Any idea what has changed?
QAugethat would be great. Nach dem einschalten kommt es zum Bootloop.