ASTM DENGL I 0b3b | This standard is issued under the fixed designation D ; the number immediately following the. This standard is issued under the fixed designation D ; the number immediately 1 This test method is under the jurisdiction of ASTM Committee D10 on. The ASTM-D standard test method for drop test of loaded containers evaluates the capability of a container to withstand the sudden shock resulting from a.
|Genre:||Health and Food|
|Published (Last):||16 July 2016|
|PDF File Size:||6.96 Mb|
|ePub File Size:||17.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
Where a hazard other than that speci? See Practice D for additional guidance. Dry and age sufficiently so that any adhesive, protective coatings, sealing tape, and so forth will have reached their? Where it is desirable to drop on a midpoint between two locations on the sidewall, such a point can be designated using four r5276, that is, drop on Your comments are invited either for revision of this d527 or for additional standards and should be addressed to ASTM International Headquarters.
The mean drop heights to failure for the three types of packaging were 39, This test method may also be used to compare the astk of different package designs. The drop height shall be measured from the top of the timber. Why perform a drop test of loaded containers?
ASTM-D is particularly suitable for containers that are normally handled manually during some part of their distribution cycle. Accelerometers or other indicating mechanisms may be installed. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
For more information visit www. A superscript epsilon e indicates an editorial change since the last revision or reapproval. If this specimen passes at this drop height, the next test will be at a higher drop height with a new package.
Last previous edition D — A number in parentheses indicates the year of last reapproval. Get to know the main factors that affect the quality of imported goods. Your email address will not be published. Sometimes the drop height, test cycles, and detailed procedures are prescribed in a contract, regulation, or some other standard. If the carton does not protect the products well enough, damage during transport may occur. ISTA 1A is a procedure designed to challenge the strength and robustness of the product and package combination.
Work Item s – proposed revisions of this standard.
ASTM D – 98() Standard Test Method for Drop Test of Loaded Containers by Free Fall
Product inspection in Hangzhou during the G20 summit. If there are more failures than passes, r5276 the height of the passes and add 1?
During transport, cartons are subject to shock, vibration, humidity and pressure. D Terminology of Packaging and Distribution Environments.
An inspection reflects the quality of products during the inspection — before loading, shipment, unloading and distribution. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Title 49 —Transportation 49 CFR 4 3.
Precision and Bias D — 98 8. Neither the depth nor width of the mass shall be less than half the length. Practice E is recommended.
This procedure varies the drop height for each drop or cycle but with a new test specimen for each. Therefore, environmental influences as present in a container are not taken into account: The values given in parentheses are for information only.
Drop test of loaded containers (cartons), ASTM D5276
This test method may also permit observation of the progressive failure of a container and the damage to its contents. Quality control inspection companies often simply refer to it as the carton drop test. This procedure determines the number of drops or cycles required to damage the package or contents.