ASTM D – Designation: D /D M – 06 Standard Test Methods for Shear Adhesion of. ASTM D/DM: Standard Test Methods for Shear Adhesion of Pressure- Sensitive Tapes. A summary of ASTM standards relating to pressure sensitive tape is attached. The shear test procedures are also harmonized: ASTM D and PSTC.
|Published (Last):||4 November 2013|
|PDF File Size:||1.17 Mb|
|ePub File Size:||6.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
The sstm of the bar for 75 mm [3 in.
As the voice of the U. Summary of Test Method 3.
ASTM D/DM – Standard Test Methods for Shear Adhesion of Pressure-Sensitive Tapes
The mass of the roller shall be 6 45 g [4. The resulting means and con? Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
The assessment may be within a roll of tape, between rolls or asstm lots. This standard is not included in any packages.
ASTM D3654/D3654M – 06(2011)
Measure any slippage that has occurred to the nearest astmm mm [1? The panel is mounted horizontally, tape side up, with the free end of the tape allowed to hang vertically over the round end x3654 the panel. Adhesion is a bond produced between a pressure-sensitive tape adhesive and a surface for Procedures A, B, C, D, and H; and, This gives the test results for the roll of tape under consideration in the sampling plan.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Owen Zhang86 NOTE 4—Discard panels showing stains, discoloration, or many scratches. If the document is revised or amended, you will be notified by email. The use of an elevated temperature during test tends to reduce the duration of the test. To be suitable, materials must be lint free during use, absorbent, contain no additives that are x3654 in the solvents listed in 6.
Practice E d36654 recommended. Take care in the choice of samples and when comparing results between fiberboard surfaces which may not be exactly the same.
By navigating on this website, you accept their use. Some computer programs for data analysis allow the use of right-censored data. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Other grades may be used, provided it is? Where width or other factors causing high adherence to backing make it impossible to remove the specimen at the prescribed rate, remove it at a rate as close to mm [30 in. The tape must be at a true right angle to the bent New panels should be cleaned before use as described in Repeat for a total of three washes with this solvent. Special isothermal box for scooters and motorcycles. You can download and open this file to your own computer but DRM prevents opening this file on another computer, including a networked server.
The mass of the clamp or hook described in 5. This test method describes procedures for determining the ability of pressure-sensitive tapes to remain adhered under constant load applied parallel to the surface of the tape and substrate.
The use of an elevated temperature during test tends to reduce the duration of the test.
The panel is mounted horizontally, tape side up, with the free end of the tape allowed to hang vertically over the rounded end. Wholesalers ads Partners Websites.
Between uses, the panels test v3654 shall be protected from scratches and contamination, and the panels stored at conditions described in 8.
ASTM D shearing tester Cell Instruments Co Import Export
We have no amendments or corrections for this standard. This standard has been approved for use by agencies of the Department of Defense.
The surface roughness height shall be 50 6 25 nm [2. The tapes tested in this study had a grand mean of 1.