This standard is issued under the fixed designation A ; the 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel. Purchase your copy of ASTM A – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. See the chemical composition and physical properties of ASTM A Grade Steel, find alternative materials, and connect with suppliers.
|Published (Last):||14 July 2010|
|PDF File Size:||15.85 Mb|
|ePub File Size:||18.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Looking for some more information? The cross section of the workpiece is reduced by the process.
Link to Active This link will always route to the current Active version of the standard. This abstract is a brief summary of the referenced standard. Two tension tests and two hardness tests shall be made from coupons obtained from each heat cast and heat treatment lot.
The ASTM A Sheet material is furnished in several conditions like heat treatments, such as hot-rolling and cold rolling; surface conditions; and edges, as specified herein, in coils or cut lengths.
The material shall be furnished in several conditions: Materials in the annealed, normalized, or normalized-and-tempered condition is capable of meeting the a50 bend test requirements.
This specification covers the standard for hot-rolled and cold-rolled alloy and wstm alloy-steel sheet and strip. Hot Rolling is employed in breaking the ingots down into wrought products such as into blooms and billets, which are subsequently rolled to other products like plates, sheets, etc. Rolling is the most important industrial metal qstm process. Offer on Fasteners Sitemap. Siddhagiri Metals and Tubes Rating: Therefore, product design in relation to the mechanical properties of the grade used must be considered.
Rolling is the deformation of materials caused by compressive force applied through a set of rolls.
ASTM A Alloy Steel Sheet Plate Strip Supplier Manufacturer Stockist
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. SI units are provided for information only. Heat analysis shall be performed on the material and shall conform to the required chemical ast for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium.
Structural alloy steel is furnished to chemical composition requirements and to specific mechanical property requirements which may include tension tests, hardness tests, or other commonly accepted mechanical tests.
ASTM A506 – 16
Siddhagiri Metals and Tubes Manufacturer: The material is pressed between a pair of rolls, which reduces the thickness and length is increased. Materials in the annealed, normalized, or normalized-and-tempered condition shall be capable of meeting the longitudinal bend test requirements. Referenced Documents purchase separately The documents listed qstm are referenced within the subject standard but are not provided as part of the standard.
Historical Version s – view previous versions of standard. This Alloy Sheet are hot rolled or cold rolled.
ASTM A506 Grade 4118
Normally surface imperfections are not objectionable, and a good finish is not a prime requirement. Heat analysis is performed on the material and is conform to the required chemical compositions for carbon, manganese, phosphorus, sulfur, silicon, copper, nickel, chromium, molybdenum, and vanadium.
Alloy steel is furnished to chemical composition requirements and is intended primarily for general or miscellaneous use where bending and moderate zstm is a requirement. Two tension tests and two hardness tests shall be made from coupons obtained from each heat cast and heat 5a06 lot. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.